Dehumidifier Fral FSW63.003 with 2 kW heating elements

FRAME
All FSW units are manufactured from galvanized sheet metal, enamel coated using polyurethane powder sintered at 180°C to ensure the best resistance to atmospheric agents. The frame is a self-supporting structure.

COMPRESSOR
Rotary compressor.
Compressor features:

High efficiency, allowing for energy savings.

Low noise level, quiet operation.

Use of HFC refrigerant for environmental protection.

High reliability, long service life.

REFRIGERATION CIRCUIT
These units use R410a refrigerant. The refrigeration circuit is manufactured in accordance with ISO 97/23 requirements regarding welding procedures and PED regulations.
The refrigeration circuit consists of:

a drying filter,

a Schrader valve for maintenance and control,

a capillary tube,

a compressor,

a condenser and an evaporator made of copper tubes with aluminum fins.

CONDENSATE COLLECTION TANK
A stainless steel tank; condensate drain connection: 3⁄4" internal.

FAN
Centrifugal fan.

AIR FILTER
Made of synthetic materials, the filter is washable and easy to replace.

MICROPROCESSOR
The microprocessor controls all the functions of the unit, such as general operation, automatic defrosting system, alarm management and humidity and temperature regulation (temperature regulation only in models with hot water heat exchanger).

CONTROL PANEL
The electrical panel complies with the electromagnetic compatibility standards (2004/108 EEC) and the electrical safety requirements for low voltage devices (2006/95 EEC).
The electrical panel includes:

Remote control terminals;

Electronic circuit board.
The installation must comply with current safety regulations and laws. If necessary, a main disconnector must be installed.

TESTS
Tests are carried out to verify the tightness of the refrigeration circuit. Electrical insulation and functional tests are also carried out. tests.

TECHNICAL STANDARDS
This dehumidifier complies with the essential requirements of the European Community Directives:

2006/95/EC (12 December 2006) on the safety of electrical products in low-voltage networks;

2004/108/EC (15 December 2004) on electromagnetic compatibility;

2006/42/EC (17 May 2006) on the safety of machinery.

Conformity is declared in accordance with the following harmonised standards: CEI-EN 60335-2-40, CEI-EN 55014-1, CEI-EN 55014-2.

It is also declared that the product is manufactured in compliance with the applicable RoHS Directive (2002/95/EC), transposed into national law by Law No. 151 of 25 July 2005 (Article 5).